Configurable and scalable system : Up to
14 IP modules or any combination of IP with ISDN/X21 modules. Cards can be hot
swapped for servicing or maintenance.
ProntoNet offers fully TCP/UDP/IP connectivity
via an Ethernet port.
Multicast, Unicast and Multi-Unicast audio
Compatibility: SIP/SAP/SDP/RTP/STUN protocols are supported according to the
standard defined by the N/ACIP project within the EBU group.
NAT Traversal Streaming Protocol permits
router firewall pass-through with zero configuration.
(Forward Error Correction). Up to
24 different schemes are available, to fit to the desired delay and available
Concealment mechanisms on Mpeg audio modes are supported to reduce the impact of packet
by Prodys enables
transmission of STL-grade audio quality over inexpensive IP links such as xDSL
connections and 3G/4G links.
Real time Network Analyzer to monitor critical network parameters in real time during the
Jitter buffer. This adjustable
buffer avoids audio dropouts compensating for up to 10 seconds of jitter in the
synchronization adjustment with the transmitter site rate, to give a constant delay in IP communications.
configurable frame size, to give
full flexibility when adjusting the delay and bandwidth use.
- Test tools to
check the bandwidth, delay and jitter in the IP connection. This information can be used to adjust the streaming
parameters and so, to obtain the best-quality in the real-time audio reception.
interface available for transmission/reception over leased lines.
adaptor available with S/T and U interfaces.
Compatibility: Fully compatible with all major audiocodec manufacturers,
supporting the most important bonding algorithms: J52, Telos and CCS bonding.
ISDN as a secondary link for IP/X21.
detection of the encoding mode used by the remote unit.
data along with the encoded audio through two user configurable RS232
ports from 300 to 115200 bps.
Ethernet port is used for audio transmission and control. The unit can be controlled remotely from its Web Page or from
through front panel leds:
o CON led: Indicates line connection status.
o FRM led: Indicates audio synchronization.
o LNK led: Indicates LAN connection.
o ACT led: Indicates LAN Tx/Rx.
o SYS led: Indicates system ready.
o A/D led: Indicates audio input selected.
LAN Management port to split audio and control data flows (optional) or to enable
SolidStream over two IP links.
remotely (TCP/IP) upgrading of one or several units at once using the same
utility. Factory software upgrades can
Call facilities: Auto-redial, call scheduler and log systems.
Prodys Redundancy Protocol allows K backup IP codecs to provide resiliency for up to N active
Access Control to define different access restrictions in a per user basis.
presets to define different configurations for all or some specific
Up to four
user configurable general purpose input-outputs (GPIO). Inputs can be set up to control audio inputs or reset
alarms, and outputs can be configured to monitor line status,
audio synchronization or alarms, among other options.
Time alarms management through SNMP
traps, GPO and e-mails
AC or DC
Redundant Power Supply.